![]() If -go is not specified but a file is downloaded or the target processor needs to be reset then it will be left in the paused state. If you specify the -go option then the target processor will be started before this tool exits. Supplied via the command line, or will be searched Name specified in generated.sh if it is not passed cpu_name CPU module name to use when trying to scan for (if not specified, will look in the same folderĪs the. Value of the Nios II CPU JTAG debug module from. write-gmon Write profiling data to the file specified when the GDB (with "auto" a free port will be used). tcpport | auto Listen on specified TCP port for a connection from stop Stop processor (leave it in a paused state). g/-go Run processor from entry point after downloading. w/-wait Wait for time specified before starting processor accept-bad-sysid Continue even if the system ID comparison fails t/-timestamp Timestamp for target-system (when last generated) This base-address must be specified in hex (0x.) s/-sidp Base-address of System ID peripheral on target r/-reset-target Reset the target SOPC system before use. JTAG debug module (auto-detected if you specifyĪn ELF file or use -directory to point to one) i/-instance Specifies the INSTANCE value of the Nios II CPU Nios II CPU (1 = device nearest TDI etc.) d/-device Specifies in which device you want to look for the c/-cable Specifies which JTAG cable to use (not needed if C/-directory Change to this directory before running get_available_software_settings 15.5.2.66. ![]() ![]() get_available_software_setting_properties 15.5.2.65. get_available_cpu_architectures 15.5.2.62. is_connected_to_instruction_master 15.5.2.42. is_connected_interrupt_controller_device 15.5.2.40. alt_instruction_exception_register() 14.1.38. alt_exception_cause_generated_bad_addr() 14.1.26. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |